Memjet Quadient Rena MACH 6, Руководство пользователя

Страница: 36 / 132

SECTION 3
OPERATING PRINTER
32
Position Media Side Guides (Inner and Outer)
1. Position Media Side Guide – Inner [B] to the
desired position and secure it using the locking knob.
Then lay a single piece of media into the hoper so it
is positioned against Media Side Guide – Inner [B].
Tip : You may need to move the Media Side Guide –
Outer [C] to provide room for the media to fit
between the Guides.
2. Position Media Side Guide – Outer [C ] so that it is
about 1/32” from the other side of media. Tighten
locking knob
[D] to secure Side Guide.
Adjust Sheet Separators
1. Loosen the locking screws, located behind Sheet
Separators
[A], and raise Separators; then tighten
the locking screws to hold the Separators in the
“Up” position.
2. Place one piece of Media (thickest area of media) under the Separators.
Loosen Separator locking screw and allow Separator to settle onto media. Then tighten locking screw.
Repeat for each Separator that has media below it.
CAUTION
To avoid damage to feed rollers and separators; make sure any
unused separators are raised and locked at their “Up” position.