SECTION 2
INSTALLING PRINTER
10
Removing Shipping Materials
1.
Open the Printhead Door.
2.
Locate and Remove the Foam Shipping Block; shown below. Color of foam block may vary.
NOTE: Foam Shipping Block is used to secure Service Station Sled position during transport.
3.
Locate, Cut and Remove the two YELLOW Zip-Ties; shown below.
NOTE: Zip-ties are used to secure the wiper motor assembly to the service station sled during transport.
Do NOT cut the white or black zip-ties used to control the position of the ink tubes.
4.
Be sure to remove all pieces of cut yellow zip-ties from the printer.
5.
Gently close the Printhead Door.
6.
Remove protective film from Touchscreen display.
7.
Remove masking tape; used to secure USB Flash Drive and Guide mounting Screws during transport.
WARNING
TO AVOID POSSIBLE DAMAGE TO PRINTER;
DO NOT PLUG-IN OR POWER-UP PRINTER
UNTIL ALL SHIPPING MATERIALS HAVE BEEN REMOVED.
CUT and Remove
Zip-Ties
(two, yellow)
Remove Foam
Shipping Block
color may vary
Содержание Quadient Rena MACH 6
Страница 1: ...Digital Color Inkjet Printer MACH 6 User Guide...
Страница 131: ......
Страница 132: ...2 1 2020 Quadient April 9 2020...