Member's Mark Y0202XC LP, Руководство пользователя, Страница: 5 / 38

To reduce the chance of "FLASH-BACK" (see
CAUTION at left) clean the Burner Tubes and
Burners before fully assembling your grill. Re-
move the Cotter Pin from the rear underside of
each Burner using a pair of long nose pliers.
Carefully lift each Burner up and away from the
Gas Valve Orifice, then refer to
Figure 1 and
perform one of these three cleaning methods:
Pre-Assembly Instructions
Bend a stiff wire, (a lightweight coat hanger
works well) into a small hook as shown
below. Run the hook through the Burner
Tube and inside the Burner several times to
remove any debris.
Use a Burner Cleaning Brush, or a bottle
brush with a flexible handle. Run the brush
through the Burner Tube and inside the
Burner several times, removing any debris.
Use an air hose to force air through each
Burner Tube. The forced air should pass
debris or obstructions through the Burner
and out the ports.
1.
2.
3.
CAUTION: Spiders and small insects occa-
sionally spin webs or make nests in the grill
burner tubes during transit and warehousing.
These webs can lead to a gas flow obstruc-
tion which could result in a fire in and around
the Burner Tubes. This type of fire is known
as a "FLASH-BACK" and can cause serious
damage to your grill and create an unsafe
operating condition for the user.
Although an obstructed Burner Tube is not the
only cause of "FLASH-BACK", it is the most
common cause.
To reduce the chance of "FLASH-BACK", you
must clean the Burner Tubes before assem-
bling your grill, and at least once a month in
late summer or early fall when spiders are
most active. Also perform this Burner Tube
cleaning procedure if your grill has not been
used for an extended period of time.
CAUTION: BEWARE OF FLASH-BACK
5
The location of the Burner Tube with respect
to the Orifice is vital for safe operation. Check
to ensure the Orifice is inside of the Burner Tube
before using your gas grill. See
Figure 2 . If the
Burner Tube does not fit over the Valve Orifice,
lighting the Burner may cause explosion
and/or fire.
ORIFICE
BURNER TUBE
BURNER PORT BURNER
SPARK ELECTRODE
GAS COLLECTOR BOX
TO CLEAN BURNER TUBE,
INSERT HOOK HERE
Figure 1
Figure 2
WARNING
!
Tools Required for Assembly
•
•
•
•
•
•
Phillips Head screw driver
Adjustable wrench
Long nose pliers - used to remove the
Cotter Pin when cleaning the Burners
Open-end wrench (included with Hardware
Pack) used to tighten the Casters.
Protective work gloves
Eye protection
GAS VALVE ORIFICE
CONTROL
KNOB
CROSS
SECTION
OF MANIFOLD
GAS COLLECTOR BOX
SPARK ELECTRODE