1
13
Place the Grill Bowl over the assembled Cart as
shown in
Figure 6
. Align the holes on both sides
of the Grill Bowl with the holes on the Support
Bracket.
From the inside of the Grill Bowl,
insert 4 "N" 1/4" x3/4" Phillips Head Screws and
4 "L" 1/4" Lock Nuts. See
Figure 6A.
Do not
tighten yet. You may need to lift the Grill Bowl
slightly to align the holes properly. Insert 2 of the
"B" 1/4"x 2 1/2" Phillips Head Screws through the
Cart Leg and Bowl Panel then tighten securely.
See
Figure 6B.
Tighten all Grill Bowl Screws,
Rear Panel and Door Bracket Screws that were
previously installed.
From the back of the Grill, slide the Grease
Draining Tray into position on the ledges under
the Grill Bowl. Center the Grease Receptacle
under the Grease Draining Tray. See
Figure 6
.
2.
Grill Head Assembly
Figure 6
GREASE RECEPTACLE
GREASE DRAINING TRAY
GRILL BOWL
Figure 6A
Figure 6B
L. 1/4" Lock Nut x 4
N. 1/4" x 3/4" Phillips
Head Screw x 4
B. 1/4" x 2 1/2" Phillips Head Screw x 2
Install the Rear Wind Shield to the back of the
Grill Cart. Secure using 2 of the "K" 3/16" x
1/2" Phillips Head Screws. See
Figure 7.
Insert the Temperature Gauge into the hole on the
upper left corner of the Grill Lid. Adjust it to level
position, then tighten securely using the Lock
Washer and Wing Nut provided in the Temperature
Gauge box. See
Figure 8.
K.3/16"X1/2" Phillips Head Screw x 2
4.
3.
TEMPERATURE
GAUGE
WING NUT
GRILL LID
Figure 8
Figure 7
WING SHIELD