Instructions
Safety advice and warnings
Failure to follow and observe these instructions could lead to
an accident.
Working environment:
- Keep the working area clean and well lit. Cluttered and
dark areas invite accidents.
- Do not place the product on hot surfaces, such as cook
ing plates, gas burners, ovens or similar.
- Keep children and bystanders away when using this
product.
- The product must be used and placed on a flat, stable
surface.
Personal safety:
- Keep any possible distractions well away from you when
using the product as they may cause you to lose your
concentration. Use common sense when operating the
product. Do not use it when tired or under the effect of drugs,
alcohol or medication. A moment of inattention while operating
this type of product may result in serious personal injury.
- Before using the product ensure that the cutting blade is
properly fixed in place.
Use and care:
- Do not use the product if the parts or accessories are not
properly fitted.
- Always leave the handle in the down position (as shown
above) after use, and before any cleaning operation or trans
portation to avoid personal injury.
- This product is intended for adult use only. Ensure that this
product is not used by the disabled, children or people unused
to its handling.
- This product should be stored out of reach of children and/or
the disabled.
- Pay special attention during the assembly and disassembly of
blades, as they are sharp and could cause harm.
- Any misuse or failure to follow the instructions for use renders
the guarantee and the manufacturer’s liability null and void.
Instructions for use
Before use:
- Make sure that all the product’s packaging has been removed.
- Before using the product for the first time, clean the parts that
will come into contact with food.
Assembly:
- Ensure you have received the cutting blade, 2 x bolts, and 2 x
nuts in the box. (Fig.1)
- Align the cutting blade as shown in Fig. 2, and fasten the nuts
& bolts until the cutting blade is firmly in place.
Height adjustment
- The cutting blade height can be adjusted, it’s just necessary to
unscrew the nut & bolt on either side (Fig. 2). Place the cut
ting blade at the desired height and tighten the nuts & bolts on
either side again.
Cleaning
- Clean the equipment with a damp cloth with a few drops of
washing-up liquid and then dry.
- Never submerge the product in water or any other liquid or
place it under running water.
Fig. 1
Fig. 2
BILTONG CUTTER
BILTONG
KING
MW_Biltong_Cutter_IM.indd 1
MW_Biltong_Cutter_IM.indd 1
11/12/2008 12:58:27 PM
11/12/2008 12:58:27 PM
