Installation
Rev 1.2
Mellanox Technologies
34
To extract a Fan Unit:
Step 1.
Grasping the handle with your hand, push the latch release with your thumb while pulling the
handle outward. As the fan unit unseats, the fan unit status LEDs will turn off.
Step 2.
Remove the fan unit.
Figure 24: Fan Module Latches
To remove or replace a fan unit, gently pull out its black handle while pus
latch release with your thumb.
To insert a FAN Unit:
Step 1.
Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
Step 2.
Insert the fan unit by sliding it into the opening until slight resistance is felt. Continue pressing
the fan unit until it seats completely
The green Fan Status LED should light. If not, extract the fan unit and reinsert it. After
two unsuccessful attempts to install the fan unit, power off the
system
before attempt-
ing any system debug.
Содержание SB7700
