MTS3610 Installation Guide
Mellanox Technologies
Rev 1.2.2
9
Step 7.
Check that none of the ATTN status LEDs on the spines are yellow.
Step 8.
Go around to the other side of the switch chassis and check the leaf board status
LEDs.
Step 9.
Check that the leaf physical and data link status LEDs in the spines are lit.
Configuring the Switch for the First Time
Step 1.
Connect the host PC to the RS-232 port of the MTS3610 switch using the supplied cable.
This LED should be off.
This LED should be on.
The green connector
LEDs should be on.
The yellow connector
LEDs should be
blinking.
Green – indicates Power OK
ATTN – Yellow indicates fault
in spine, normally off
Green – indicates that
there is a physical connec-
tion to the spines through
this link
Yellow – indicates that there
is a logical connection to the
spines through this link
Links A and B to each leaf
Leaf numbers
RS-232 port
