Rev 2.9
Mellanox Technologies
8
Revision History
Table 1 - Revision History Table
Date
Revision
Description
June 2011
Rev 2.9
Removed references to paper clip.
Changes to reset button section
Added warning do not use the switch as a shelf.
June 2011
Rev 2.8
Changed three minute boot up time to 5 minutes.
June 2011
Rev 2.7
Removed Flashing green from Table 4
June 2011
Rev 2.6
Removed products scheduled for End of Life.
Removed Flashing green from Table 4
May 2011
Rev 2.5
Fixed power numbers
May 2011
Rev 2.4
Changes to Sections 1.1 and 2
May 2011
Rev 2.3
Changes to the mangement sections
Removed Section 6
May 2011
Rev 2.2
Changed Grounding section.
Removed note from Table 4
Changed unmanaged FW update procedure
Oct. 2010
Rev 2.1
Added information regarding the MIS5031 port numbering and port activation.
Oct. 2010
Rev 2.0
New power numbers
Cable power level changed to 2.0W level 2
July 2010
Rev 1.9.1
Added “QSFP Cable Power Budget Classification”
June 2010
Rev 1.9
Added section Getting the License
Added Note “Each Ethernet connector gets connected to Ethernet switches. These
switches must be configured to 10/100M auto-negotiation.”
April 2010
Rev 1.8
Added appendix with instructions for bringing the power cord from one side of the
switch to the other in a full rack.
Added Safety Warnings in Spanish
April 2010
Rev 1.7
Removed DDR switches.
January 2010
Rev 1.6
Added instructions in the installation section regarding putting the power cord through
the bracket Figure 15 and note on page 26.
Removed DDR switches.
January 2010
Rev 1.5
Updates figures to include the power side I2C connector.
Added Section 3.3.2.5 I2C Interface on the power side of the switch
December 2009
Rev 1.4
Added Chapter 6 regarding FabricIT-EFM licensing information.
Added Chapter 2Management modules and CPU connections
Section 4.3 on unmanaged switches including
The I2C connector should only be used when the FW cannot be updated in-band.
