Rev 1.5
Mellanox Technologies
46
Figure 14: Gasket Installation
4. Place the bracket onto the card until the screw holes line up.
5. Screw on the bracket using the screws and washers saved from the procedure above step 1.
Figure 15: Placing the Bracket on the Card
6. Make sure that the LEDs are aligned onto the bracket holes.
7. Use a torque driver to apply up to 2 lbs-in torque on the screws.
Do not force the bracket onto the card. You may have to gently push the LEDs using a
small screwdriver to align the LEDs with the holes in the bracket.
Gaskets in
place on the
bracket.
