Meler Micron 5, Инструкция по эксплуатации

Страница: 71 / 118

MAINTENANCE
5-1
MA-5079-ENG MICRON GEAR ADHESIVE MELTER
5. MAINTENANCE
Warning: The melter equipment is equipped with current technology, but
has certain foreseeable risks. Therefore, only allow qualified personnel with
enough training and experience to operate install or repair this equipment.
The following table briefly summarizes the indications for adequate melter/
equipment maintenance. Always read the corresponding section carefully.
If the equipment does not work or works incorrectly, you can requested help
from our Technical Service.
Equipment cleaning
To continue to take advantage of the melter’s benefits and to ensure the
perfect mobility of its components, it is necessary to keep all its parts clean.
Warning: Risk of electric shock. Carelessness may result in injury or death.
Clean the exterior using a cloth moistened with water. Do not use flammable
liquids or solvents.
Operation Frequency Refer to
External cleaning Daily Equipment cleaning
System depressurization
Before performing maintenance tasks
and repairing the hydraulic system
System depressurisation
Remove electrical cabinet
Before performing maintenance of
distributor, pump or gear motor
Access inside the unit
Filter cleaning or changing
- As needed (once a year minimum)
- With each adhesive change
Filter maintenance
Emptying and cleaning the tank
- When burnt adhesive is present
- With each adhesive change
Cleaning the tank
Check for pump leaks
Depending on the hours of operation and
the temperature and speed parameters
(min. once per month)
Pump maintenance
Check the lubrication (motor and
gear)
Depending on the temperature and con-
ditions of use (max. 8000 hours)
Gear motor maintenance
Check thermostat operating - Checking while working Safety thermostat
Air dryer filters (option)
- Purge water condensation (weekly)
- Clean the filter (at least twice a year)
Air filter maintenance
Equipment change - Equipment change or repair Remove the equipment from its base