Meler MACRO FOAM Series, Инструкция по эксплуатации, Страница: 21 / 88

INSTALLATION
3-1
MA-5127-ENG MACRO FOAM SERIES MELTER MANUAL
3. INSTALLATION
Warning: The melters are equipment with current technology and with certain
foreseeable risks. Therefore, only allow qualified personnel withsufficient
training and experience to use, install or repair this equipment.
Introduction
The Macro Foam series melters are delivered with all the materials necessary
for their installation. However, some components must be provided by the
user himself, according to the location and connections in each particular
installation:
• Anchoring screws for the melter equipment if required.
• Power cord and plug for electrical power.
• Pneumatic conduct and connection to the compressed air system.
• Multicore cable for external electrical control.
• Optionally, a gas ventilation system.
Installation requirements
Before installing Macro Foam series melter equipment, we must make
sure that the space assigned to it permits installing, connecting and using
the entire system. Similarly, we must check to see that the electrical
and pneumatic supplies meet the necessary requirements of the melter
equipment being installed.
Free space
F
E
G
A B
D
C