Meler B4 NON-STOP, Инструкция по эксплуатации

Страница: 21 / 78

3-3
INSTALLATION MA-5081-E B4 NS ADHESIVE MELTER MANUAL
Unpacking
Before installing the melter, it should be removed from the pallet and
inspected to detect any possible breakage or damage. Notify your Meler
Representative or the Main Office of any defect, even to the outer packaging.
Contents
The B4 NS melter packing materials may contain accessories requested in the
same order. Otherwise, the standard components included with the melter are
as follows:
• Instruction manual
• Guarantee card
Mounting the equipment
The B4 NS melter includes an assembly base plate for easy mounting.
The base plate makes it easy to remove and position the melter. To mount the
base plate, place it on the machine bench and position. Mark and drill four
holes for the base plate’s M8 fastening screws. The holes may be threaded or
through holes depending on the bench on which they are being mounted.
Warning: Make sure the bench on which the base plate is being mounted is
level, free from vibrations and able to support the weight of the equipment
plus the full tank load.
Once the base plate has been secured to the bench, the melter should be
mounted on top.
Fit the retaining flanges onto the base and position the four fastening screws.
Electrical power supply connection
The B4 NS melter is designed to be connected to the electrical power supply
with single-phase 230 VAC and neutral, depending on the power consumption.
In any case a good ground connection is required.
The maximum consumption values are shown in the table attached:
Warning: Risk of electric shock. Carelessness may cause injury or death.
Unit Pump No. Outputs Max. connecting power
unit only with outputs installed
B4 NS gear 2 9,7A 16A