MELAG Vacuklav 23 B+, Техническое руководство, Страница: 9 / 24

2 Installation requirements
9
Connection of a water treatment unit
MELAdem 40 MELAdem 47
Permissible water
pressure 1.5-10 bar 2-6 bar
Water stop For insurance reasons, MELAG recommends the installation of a water stop
with a cut-off valve (e.g. from MELAG), as the MELAdem 40 / MELAdem 47
are under constant water pressure from the domestic water supply.
PLEASE NOTE
The outlet hose must be fitted at a constant decline without kinks or sagging. Deviations
to the installation arrangements require consultation with MELAG.
Failure to do so can result in malfunctions of the steam sterilizer.
System and network safety
The device is fitted with multiple external interfaces. Comply with the following information pertaining to the
use of these interfaces to ensure safe operation of the device, especially to ensure incorporation in the lo-
cal network (LAN).
Interfaces and connections
NOTICE
Only connect the hardware to the device which is listed in the following table. Only use
the software which has been intended for the purpose and approved by the
manufacturer.
Interface Type Hardware Purpose/software
COM port RS-232 PC MELAview
saving log data and querying device data
MELAtrace
saving log data
Modem Data transfer via points of presence
MELAnet Box Provides a LAN (Ethernet) interface for
the device, see below (Ethernet)
MELAview/MELAtrace
Saving log data
FTP server
saving log data
MELAprint 42/44 Log printing
MELAflash CF card printer Writing log data on a MELAflash CF card
NOTICE
When performing a device software update, use only the update data authorized by
MELAG for the corresponding device type.