MEITRACK T633G User Guide
Copyright © 2019 Meitrack Group All rights reserved. - 4 -
1
Copyright and Disclaimer
Copyright © 2019 MEITRACK. All rights reserved.
and
are trademarks that belong to Meitrack Group.
The user manual may be changed without notice.
Without prior written consent of Meitrack Group, this user manual, or any part thereof, may not be reproduced for
any purpose whatsoever, or transmitted in any form, either electronically or mechanically, including photocopying and
recording.
Meitrack Group shall not be liable for direct, indirect, special, incidental, or consequential damages (including but not
limited to economic losses, personal injuries, and loss of assets and property) caused by the use, inability, or illegality
to use the product or documentation.
2
Product Introduction
The T633G is a brand new 3G vehicle tracker specially designed for Thailand DLT project. This unit can connect to
multiple accessories: magnetic card reader, camera and LED display. In addition, it supports driving behavior analysis,
fuel level monitoring and temperature monitoring and its performance has been significantly improved.
2.1
Product Features
2.1.1
Idling Detection
When the device detects that the vehicle stops moving for a long time and the ACC is on, an idling alert will be
generated and the buzzer will make sounds every 0.5 seconds. When the ACC is off or the vehicle starts moving, the
device will exit the idling state and the buzzer will not make sounds.
To implement this function, you must connect device's input 3 to ACC detection cable and output 2 to the buzzer, or
connect device's input 3 to ACC detection cable and ensure that the magnetic card reader supports buzzer alerts.
For details, see the section 6.6.2 "Setting the Idling Alert – B14."
2.1.2
Fatigue Driving Detection
When the device detects that the driver has been driving a vehicle for a long time, a fatigue driving alert will be
generated the buzzer will beep twice every 1 second.
To implement this function, you must connect device's input 3 to ACC detection cable and output 2 to the buzzer, or
connect device's input 3 to ACC detection cable and ensure that the magnetic card reader supports buzzer alerts.
For details, see the section 6.6.3 "Setting Fatigue Driving – B15."
2.1.3
Controlling Buzzer Sounds
When the device detects speeding, the buzzer will make sounds (BI-BI-BI-BI).
To implement this function, you must connect device's output 2 to the buzzer or ensure that the magnetic card reader
supports buzzer alerts.
For details, see the section 6.6.1 "Setting the Speeding Alert – B07."
