MEITRACK T400G TPMS Scheme User Guide
Copyright © 2019 Meitrack Group All rights reserved. - 32 -
the 6-digit ID number of the sensor, the ID number will be showed on the LCD display and the red LED indicator will
be off. When the buzzer makes a long sound "Bi", it means that code matching is performed successfully and the ID
number will be stored automatically. If you do not receive the ID number within 6 seconds, you will hear "Bi" twice,
the red LED indicator will be off, and "Id Err" will be showed on the LCD display, which indicates that code matching
fails to be performed. Please rotate the direction of the sensor or LCD display, or place the bottom of the LCD display
close to the sensor requiring code matching, and then press the
CODE
key to preform code matching again. Press the
+
key to select the next tire requiring code matching, and perform the same steps to complete code matching. If the
codes are the same, the previous same ID number will be deleted automatically. After all the ID numbers are matched
codes successfully, perform one of the following steps to exit the settings state or enter normal working status: (1)
do not press any key for 3 consecutive minutes to exit the settings state; (2) press and hold down the
CODE
key for
3 seconds. After you hear "Bi" once, release the key. The LCD display will return to normal working status.
Code matching success: The ID number is showed after the corresponding tire is selected.
Code matching failed: "Id Err" is showed on the LCD display.
8.2.2
Manual Code Matching
In standby mode, press and hold down the
CODE
key of the LCD display for 6 seconds (continue to press the key
when you hear the first "Bi" sound; release the key when you hear the second "Bi" sound). The system will enter
manual code matching mode, and the ID number of the current tire will be showed on the LCD display. Press the
+
or
-
key to select the tire requiring code matching, and press the
SET
key to confirm. Then press the
CODE
key to
switch the digits of the 6-digit ID number, press the
+
or
-
key to set the value of the ID number, and press the
SET
key to store. Press the
+
key to select the next tire requiring code matching, and perform the same steps to complete
code matching. After all the ID numbers are matched codes successfully, perform one of the following steps to exit
the settings state or enter normal working status: (1) do not press any key for 3 consecutive minutes to exit the
settings state; (2) press and hold down the
CODE
key for 3 seconds. After you hear "Bi" once, release the key. The
LCD display will return to normal working status.
8.2.3
Deleting ID numbers
Deleting an ID number in ID number querying mode:
In standby mode, short press the
CODE
key of the LCD display. When you hear "Bi" once, the system will enter ID
number querying mode. Press the
+
or
-
key to select the location of the tire to be deleted, and press and hold down
the
SET
key for 3 seconds. If you hear "Bi" twice, it means that the tire's ID number is deleted. In this way, perform
one of the following steps to exit the settings state or enter normal working status: (1) do not press any key for 3
consecutive minutes to exit the settings state; (2) short press the
CODE
key. After you hear "Bi" once, release the key.
The LCD display will return to normal working status.
