MEITRACK MT90L User Guide
Copyright © 2019 Meitrack Group All rights reserved.
- 10 -
lifespan or performance. If the battery is low, it may
affect positioning and data transmission. So you need
to charge the battery before using.
5.
Charge the battery by magnetic charging
connector.
Remove the USB rubber cover, plug the magnetic
charging connector into the USB port, connect one
side of USB cable to the magnetic conversion
connector, and then attach the conversion connector
to the magnetic charging connector. When the device
is charging, the blue LED indicator for the conversion
connector will steady on.
Note: When the device is charged fully, please do not
parallel pull the conversion connector out. (Magnetic
charging connector may be pulled out from the USB
port.) You need to rotate an angle of 90 degrees and
then pull the conversion connector out.
Charge with the travel adapter:
Open the cover of the multifunctional jack of the
device. Plug the small end of the adapter into the
multifunctional jack. Then plug the larger end of the
travel adapter into a power outlet.
Note: Incorrect connection may cause serious
damages to the device. Any damage caused by
misuse is not covered in the warranty.
Attach a lanyard:
Slide the lanyard through the slot and hook it over
the small projection.
Once you have installed the battery and SIM card, you can turn on your device and start using it.
Please read the following instructions to know more about its functions.
7
Quick Operation Command
Before use, common parameters must be set by SMS command or Meitrack Manager
7.1
Tracking by Mobile Phone
This section describes how to query device's current location, ensuring that the GPS is working normally.
