MeiTrack GT30i, Руководство пользователя, Страница: 7 / 24

- 7 -
4.4.2 Charge the battery for at least 3 hours in power-off status
using the wall or car charger. You can also connect the tracker
directly to the computer by USB for charging. Red light is on
during charging and off when charging is complete.
4.4.3 Push the Power On/Off button to the ON side and wait for
about 20 seconds. The device will then enter standby mode. It is
suggested that you turn on the device outside of all buildings to
receive a better GPS signal.
Check that the Red LED (Battery) is flashing 1 second on and 2
seconds off.
Check that the Green LED (GSM) is flashing 0.1 second on and 2.9
seconds off.
Check that the Blue LED (GPS) is flashing 0.1 second on and for
2.9 seconds off.
5. Change Password
Command : W******,001,######
Description : Change user‟s password.
Note :
1. ****** is user‟s password and the default password is 000000. The tracker will only accept commands
from a user with the correct password. Commands with wrong password will be ignored.
2. ###### is the new password. Password should be 6 digits.
Example :
W000000,001,123456
W123456,001,999999
6. Time Zone
Command : W******,032,T
Description : Correct time to your local time.
Note :
1. Default time of the tracker is GMT.
2. This correction is applied to location reports by SMS and SMS alarms.
T=0, to turn off this function;
T=_[-32768,32767] to set time difference in minutes to GMT.
For those ahead of GMT, input the time difference in minutes directly.
For example, for GMT+8, W000000,032,480. (8 Hours is 480 minutes)
„-„is required for those behind GMT.