, MEI., 1997
39
CashFlow
®
540 changegiver Pocket Guide
Connect the looms and secure them
in their correct positions
1. Check that the looms cannot be trapped by the
unit or by the door of the machine.
2. Check that the unit’s lid opens fully when the
reject button is pressed, and that the lever has
2mm - 3mm of clearance from the reject
mechanism of the machine
.
Adjust the clearance if
necessary.
3. Ensure that the unit’s coin entry cup is
aligned with the machine’s coin entry chute,
and that the coin exit chutes are lined up.
4. With the power off, insert ten of the largest and
smallest coins to check the coin routing to the coin
return cup.
Switch on the power to the unit
1. Check that the red LED comes on.
2. Set the vend prices with the keypad or with the
Route Alpha 250 terminal.
NOTE: The keypad is suitable if the
installation has an electromechanical or
Executive interface. If the installation has an
electronic serial interface such as MDB,
where prices are normally held in the
vending machine, it is not appropriate.
Push open the top
cover flap to get
access to the
fixing screw and
to tighten it