Megger torkel 820, Руководство пользователя

Страница: 14 / 58

1 4
T O R K E L 8 2 0 / 8 4 0 / 8 6 0
P r o g r a m m a E l e c t r i c A B
Z P - B S 0 6 E R 1 0 1
5
Conducting a test
Note Press ESC if you want to access the main
menu.
Important
Connection and disconnection proce-
dures are extremely important. Be sure
to follow the the instructions faithfully.
Connecting the current
cables to the battery
Use the cables supplied with TORKEL or other cables
of suitable size. Follow the numbered steps that are
set forth below. Inspect each connection to make
sure it is securely fittted.
Connecting TORKEL to a battery.
Connect one end of the first cable to the nega-
tive (-) terminal on TORKEL.
Connect the other end of the first cable to the
negative (-) pole of the battery.
Connect one end of the second cable to the
positive (+) pole of the battery.
Connect the other end of the second cable to
the positive (+) terminal on TORKEL.
Tip To get a more accurate voltage read-
ing. Connect the voltage sensing cables
between the “VOLTAGE SENSE” input
on TORKEL and the battery terminals.
1]
2]
3]
4]
Test at constant
current
Safety precautions
Warning
Do not connect or disconnect any of the
cables unless the circuit breaker F1 is in
the lower (OFF) position.
Never use TORKEL/TXL Extra Load in
an explosive environment. Never put
TORKEL/TXL Extra Load in direct contact
with battery gas.
Position TORKEL/TXL Extra Load so that
the air flow is unobstructed and free from
contact with any flammable or heat-sensi-
tive material.
Do not place TORKEL near another
TORKEL, a TXL Extra Load or any other
heat source. TORKEL will overheat if there
is insufficient cooling.
Inspect cable connections to make sure
there is no short circuit.
Preparations for testing
Connect TORKEL to the mains voltage.
Switch on TORKEL.
The following display will appear for a short time:
TORKEL 840 R01A
It will then change to:
MAIN MENU
Test battery
and then:
Connect battery
1]
2]