Megger Easyloc Basic, Руководство по эксплуатации

Страница: 20 / 35

4-20
4.1.3 Initial use of the transmitter
How to proceed Follow the steps listed below in order to prepare the transmitter to search for lines
in conjunction with the receiver:
Step Action
1 Connect the transmitter to the line to be located using the most suitable
method, or place the transmitter on the site to be searched (see section
4.1.2 Options for direct and inductive signal coupling ).
2
Press
to switch on the transmitter.
3
Select the desired output signal using the and buttons (see
section 4.1 Connection and initial use of the Easyloc Tx transmitter ,
page 4-14 ).
A green LED indicates that the respective setting is active.
4
Select the desired mode of operation using the button (see section
4.1 Connection and initial use of the Easyloc Tx transmitter , page 4-14 ).
Result : In Direct mode, an LED next to the
symbol indicates
how good the connection is to the connected line:
• Green blinking : good (low-resistance) connection
•
Alternating red and green
: sufficient connection
• Red blinking : poor/no (high-resistance) connection
5 As described in chapter 4.2 Locating lines with the Easyloc Rx receiver
use the Easyloc Rx to locate metallic conductors.
C
M P
www.calcert.com sales@calcert.com 1.800.544.2843
0
5
10
15
20
25
30