Step 1). Disconnect the black/grey ON/OFF switch ribbon connector (Fig 6 &
Fig 7)
Mega-Catch™ Mosquito Traps have a modular design that enables the user to
easily perform maintenance/repairs on the Trap without the costly charges
required to send the Trap to a service centre.
Please refer to the instructions below on how to correctly open the mosquito trap.
ENSURE POWER IS DISCONNECTED
To Open Your Mosquito Trap
Fig 1
Fig 4
Fig 3
Fig 2
Step 2). Remove the On/Off switch through the front of the unit by
exerting pressure on the switch from the inside of trap (Fig 8 & Fig 9).
Step 3). Replacement is the reverse of removal.
Take care when inserting connector and ribbon
cable through front of unit.
Ensure rubber backing washer in place (Fig 10).
Fig 7
Fig 6
Fig 9
Fig 8
Fig 10
To Replace the On/Off Switch
Fig 5
Place the Trap on a table or other suitable flat surface ensuring the ON/OFF switch
is facing downwards (Fig 1) remove 6 bolts. Turn Trap over (Fig 2) so that the
ON/OFF switch is now face up and remove 6 bolts.
Raise ‘Front Half’ of Trap (Fig 3) a couple of inches. Then ‘flip’ the ‘Front Half’ over
(Fig 4) as if it were hinged at the top. The ON/OFF switch is located in the ‘Front
Half’ of the Trap as shown (Fig 5).
‘Rear Half’
ON/OFF switch
‘Front Half’
REPLACEMENT INSTRUCTIONS
Pro 900 PREMIER
ON/OFF SWITCH
