Medrad Mark 7 Arterion, Руководство по эксплуатации

Страница: 52 / 162

MEDRAD
®
Mark 7 Arterion Injection System
9 - 44
9.2 Manage Protocols from the Protocols Tab
NOTE:
To store, view, or edit mL/m, Phased, or Variable Flow Rate protocols, enable that
protocol type from the Display Control Unit
Options tab. See "6.4 - Options Tab" . If
the mL/m option is enabled, only mL/m protocols display.
9.2.1 Create Protocols
The injection system can store up to 40 protocols. The number of protocols stored on the system
displays in the upper right corner of the
Protocols tab. Each protocol stores the volume, flow rate,
pressure limit, rise time, and delay.
NOTE:
Refer to syringe and disposable packaging to confirm lowest pressure rating prior
to programing and injection.
9.2.1.1 Create a New Single mL/s or mL/m Protocol on the Protocols tab
A Single protocol consists of a single volume, flow rate, pressure limit, rise time, and delay.
NOTE:
Delay and rise time are not available for mL/m protocols.
1.
Select the Protocols tab.
Figure 9 - 4: Protocols Tab - Single Protocols
2.
Select the Type (B) button until Single is highlighted. A list of Single protocols displays.
3.
Select the blank blue button (A).
NOTE:
If a blank button is not visible, scroll through the list of protocols until one displays.
If a blank button is not available or
0 Available displays in the upper right corner,
the system cannot store any more protocols. Delete a protocol to add a new one.
4.
Enter the protocol name.
5.
Select a parameter and enter the values for the selected parameter.
NOTE:
If an operator tries to commit a value outside of the acceptable range, an audible
beep sounds and the parameter range blinks in the keypad.
6.
Select a different parameter to commit the values.
7.
To enter a delay, select Delay .
a.
Enter the delay time. Setting the delay time to zero is equivalent to having no delay.
b.
Select X-Ray or Inject .
NOTE:
A programmed delay parameter only functions when using ISI.
8.
Select Save .