P3V Veterinary Digital Ultrasonic Diagnostic Imaging System User Manual
- 62
-
3.
In simulative operation, the final radiating surface temperature of probe L743-2 is
41.41
℃
.
4.
In simulative operation, the final radiating surface temperature of probe C361-2 is
41.7
℃
.
6.5. Selecting an Imaging Mode
You can select an imaging mode by pressing
,
,
,
,
, or
, and
then begin an examination.
Reference Section
5.4.7, Imaging functions
and section
5.2, Examining
.
6.6. Measurements and Calculations
Measurement and calculation functions are contained in each examination type and imaging
mode. Distance and circumference will be presented in mm; area, in
mm
2
,
cm
2
,
or dm
2
; volume,
in
mm
3
,
cm
3
,
dm
3
,
mL or L; time in ms or s, and heart rate in bpm, etc.
To activate the measurement function, press
Measure
, and the light will be on.
There is one type of mark in B mode measurement: “+”.
There are three types of marks in M mode measurement: “+”, big “+”, and a line.
The measurement results will be displayed in real-time. After measurement, the outcome is
displayed in measurement result window with a serial number. You can measure one to four
groups of data. If you continue to measure, the earliest group will be automatically covered by the
newest one.
NOTE:
1. If you perform the measurements in the frozen status, all the measurements will be
cleared when you unfreeze the image.
2. During measurement, press
Back
to delete the
previous operation.
3. After a complete measurement, press
Back
to erase a measurement at a time.
The generic measurements and calculations include four sets of measurement calipers, four sets
of ellipses, four sets of measurement results at most.
The examination labels and results are shown in table 6-1.
