16
To remove the stand, push the stand towards the rear of the device and
then pull it from the device.
Wall mounting
You can attach the main device to a wall. To do so, you must attach two
screws to the wall. The heads of the screws must fit into the keyhole
notches on the back of the device.
ATTENTION!
Before drilling the holes for assembly, make sure that there are no
power or supply cables or pipes in the wall.
Mark the holes to be drilled. Distance between the drill holes for device:
160 mm. Drill 2 holes for 6 mm wall plugs using these markings.
Insert 6 mm plastic wall plugs into the drilled holes. Insert the screws
into the wall plugs and tighten them with a screw driver.
Hang the device using the keyhole notches provided and fold out the
spacer so that the device hangs straight on the wall.
Aerial connection
Connect an aerial cable to the FM ANT Ohm aerial connection on the
device to enable radio reception.
A wire aerial is included in the delivery. Connect the wire aerial to the
device and position it to achieve the best reception (1).
Alternatively, you can connect an aerial cable to an appropriate wall
socket (2).
