MVC Pro User Guide – English
MVCPro-UG01-EN-211004-OB
<
6
>
The unit is for exclusive interconnection with IEC60601 certified equipment in the patient environment and IEC60XXX
certified equipment outside of the patient environment.
A certified power supply cord set must be used with this equipment. The relevant national installation and/or equipment
regulations shall be considered. The power supply cord shall be not less robust than an ordinary tough rubber-sheathed flexible
cord according to IEC 60245 (designation 53) or ordinary polyvinyl chloride sheathed flexible cord according to IEC 60227
(designation 53).
Connecting the MVC Pro SDI to HDMI
Conversion input / output
4K SDI input
4K HDMI output
2160p60
2160p30
2160p50
2160p25
Front Panel
Back Panel
USB connector
No function.
For firmware
updates only.
Pro SDI to HDMI
Equipotential
Pole
Power connector
Use supplied power cable to connect 100V-240V outlet.
4K / HD out 2
Loop out
SDI in
A
B
C
D
A
B
C
D
4K / HD out 1
SDI loop output
of the original SDI input
SDI Input
Various input options are possible for 4K-SDI
4K or HD
HDMI Output (2)
l=On
(connection
to power supply,
mains)
O=Off
(no connection
to power supply,
mains)
Power Switch
This MVC Pro connects to an SDI video source (for example, an endoscopic camera, surgical camera, ultrasound, etc.).
1. If you are adding the MVC Pro to imaging equipment that you are already using, begin by locating the video
output of the primary video source.
2. Connect the appropriate SDI cable(s) between the video output on the video source and the appropriate SDI
video input on the back panel of the MVC Pro.
There are several connection options possible.
Selection of functions: MVC Pro has no user interface.
It changes functions by auto-detecting SDI input signals.
4x 3G-SDI input conversion into 2x HDMI 4K output.
3. Plug in the power cord.
4K / HD out 2
Loop out
SDI in
A
B
C
D
A
B
C
D
A
B
C
D
4K / HD out 1
4K-SDI Camera
4K HDMI Recorder
