LinkIt 2523 HDK v11 User's Guide
© 2015 - 2016 MediaTek Inc.
Page 27 of 82
This document contains information that is proprietary to MediaTek Inc. (“MediaTek”) and/or its licensor(s).
Any unauthorized use, reproduction or disclosure of this document in whole or in part is strictly prohibited.
line
shown below.
Set the jumper J1006 pins to assign the storage command line to eMMC, as shown
below.
Figure 16. Jumpers J1001 to J1006 for storage options
4.11.
Camera
Connect the camera daughterboard (see Figure 23) to the camera connector to enable the camera. The sensor
daughterboard features are shared with camera using a jumper (see Table 15 and Figure 17). The LinkIt 2523 HDK
supports serial interface cameras.
Top to Bottom
J1001
J1002
J1003
J1004
J1005
J1006
1 2 3
1 2 3
1 2 3