Medias Mediatrix 1204, Справочное руководство

Страница: 102 / 390

Chapter 5 - Web Interface – Telephony Digit Maps
76 Mediatrix 1204
General Parameters
The following are the general digit maps parameters you can set.
You can also set these parameters via SNMP, as described in “Chapter 21 - Digit Maps” on page 243 .
X
To set the general digit map parameters:
1. In the web interface, click the Telephony link, then the Digit Maps sub-link.
Figure 34: Telephony – Digit Maps Web Page
2. In the General section, define the value of the “T” digit in the Digit Map Timeout Inter Digit field.
The “T” digit expresses a time lapse between the detection of two DTMFs. This value is expressed
in milliseconds (ms). Values range from 500 ms to 10000 ms.
3. Define the time between the start of the dial tone and the receiver off-hook tone, if no DTMF is
detected, in the
Digit Map Timeout First Digit field.
This value is expressed in milliseconds (ms). Values range from 1000 ms to 180000 ms.
4. Define the total time the user has to dial the DTMF sequence in the Digit Map Timeout Completion
field.
The timer starts when the dial tone is played. When the timer expires, the receiver off-hook tone is
played. This value is expressed in milliseconds (ms). Values range from 1000 ms to 180000 ms.
5. Click Submit if you do not need to set other parameters.
2
4
3