Media5 Mediatrix C710, Руководство по установке оборудования

Страница: 27 / 52

IP Address Discovery or Configuration Hardware Installation Guide
Mediatrix C7 Series – Digital Gateway 15
This procedure is called a partial reset. After a partial reset is performed, the Mediatrix C7 Series
uses the default IP address 192.168.0.1/24. Refer to
“Partial Reset” on page 19 for details on the
partial reset procedure.
The corresponding link-local IPv6 address is also available and printed on the sticker under the
Mediatrix C7 Series.
You can now access the Mediatrix C7 Series web interface. Refer to the
Software Configuration
Guide for more details.
IPv6 Link Local Address Configuration
If there is no DHCPv6 server or IPv6 router in your network, you can use the link local address to contact the
unit. Note that the Mediatrix C7 Series IPv6 interface is disabled by default.
1. With a 10/100 Hub and two 10/100 BaseT Ethernet RJ-45 straight cables, connect both cables to
the Hub; one of them is connected into the
ETH1 connector. The other cable links the computer to
the Hub.
2. The Mediatrix C7 Series should be already running. If not, power it on by connecting the other end
of the power adaptor to an electrical earthed sockt-outlet. The electrical outlet must be installed near
the Mediatrix C7 Series so that it is easily accessible.
3. Insert a small, unbent paper clip into the Reset / Default hole located at the rear of the Mediatrix
C7 Series.
The
Power LED will start blinking, and after a few seconds, all the LEDS will start blinking. Release
the paper clip after all the LEDs start blinking and before they all stop blinking (between 7-11
seconds).
This procedure is called a partial reset. After a partial reset is performed, the Mediatrix C7 Series
enables its link local IPv6 address. Refer to
“Partial Reset” on page 19 for details on the partial reset
procedure.
The corresponding link-local IPv6 address is also available and printed on the sticker under the
Mediatrix C7 Series.
4. Proceed with accessing the Mediatrix C7 Series’s web interface by using the unit’s link local
address.
The unit’s link local address is printed on a sticker under the unit.
The link local address can be determined by using the following pattern: [fe80::290:f8ff:feXX:XXXX]
where XXXXXX are the last 6 digits of the unit’s MAC address. Example: The link local address for
the Mediatrix C7 Series with MAC address 00:90:F8:12:34:56 would be
[fe80::290:f8ff:fe12:3456] .
Vocal Unit Information
When entering special characters on your telephone pad, the Mediatrix C7 Series talks back to you with
relevant information. This is available only for units with FXS interfaces.

To access vocal unit information:
1. Take one of the telephones connected to the Mediatrix C7 Series.
2. Dial one of the digits sequence on the keypad.
Note:
On Windows, a scope ID needs to be added to the link local address ([fe80::290:f8ff:fe12:3456 %11 ]).
You can find this number by executing the ‘ipconfig’ command in a command prompt. Note the number at
the end of the IPv6 default Gateway for the interface used to contact the unit.
On Linux, the scope identifier may be the link name or the interface number. The interface number can be
determined through the Linux command line.
Table 5: Vocal Unit Information
Digits to Dial Information Vocally Sent by the Mediatrix C7 Series
*#*0 Current IP address of the Mediatrix C7 Series (static or DHCP).