Media5 Mediatrix C710, Руководство по установке оборудования

Страница: 23 / 52

Hardware Installation Hardware Installation Guide
Mediatrix C7 Series – Digital Gateway 11
Hardware Installation
This section describes how to set the connectors of the Mediatrix C7 Series.
See “Appendix B - Cabling Considerations” on page 29 for more details on the cables the Mediatrix C7 Series
uses.
Connecting Cables
The following describes how to connect the various cables to the Mediatrix C7 Series.
Figure 5: Mediatrix C7 Series Hardware Installation

To install the cables:
1. Before you begin, be sure that the Mediatrix C7 Series is powered off.
2. Connect the power adaptor to the Mediatrix C7 Series. Connect the other end to an electrical
earthed socket-outlet.
3. Models with FXS ports : Connect analog telephones or fax machines into Ports 1, 2, 3, and 4.
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
4. Models with FXO ports : Connect a SCN line into FXO Ports 1, 2, 3, and 4.
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
5. USB: TBD
6. Connect a 10/100 BaseT Ethernet RJ-45 cable into the ETH1 connector of the Mediatrix C7 Series;
connect the other end to a compatible Ethernet interface that supplies TCP/IP network access (e.g.,
router, switch, hub or computer).
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
7. Connect a 10/100 BaseT Ethernet RJ-45 cable into the ETH2 connector of the Mediatrix C7 Series
and connect the other end to the network card of a computer.
Caution:
The Mediatrix C7 Series must be installed on a circuit equipped with a breaker so that you can
easily power the unit off if required.
Warning:
To avoid electrical shock, apply the following instructions:
•
The device must be installed by technical personnel.
•
Be sure the ground path is connected.
•
Disconnect the FXO (SCN) and FXS Long Loop (if applicable) interface connectors before
disconnecting the power cord from the device.
Note:
The FXS and FXO ports may differ location depending on the model you have.
1 2 3 4 1 2 3 4
FXO FXS
ETH2 ETH1 USB
Power
Reset /
Default
12V 2.5A
2
4
6
3
5
7
Note:
The Mediatrix C7 Series telephone line interface has been designed to interface with a conventional
telephone or fax machine. Connections to FXS ports of third party devices such as a PBX / Key System
could damage the Mediatrix C7 Series.