Media5 Mediatrix C710, Руководство по установке оборудования

Страница: 20 / 52

Chapter 2 - Installation Required Mounting Tools and Equipment
8 Mediatrix C7 Series – Digital Gateway
Required Mounting Tools and Equipment
You will need the following tools and parts to properly install the Mediatrix C7 Series:

ESD-preventive wrist strap.
In addition, you might need the following external equipment:

Modem for remote access.

RJ-45 cables for the WAN and LAN connections.
Unpacking and Inspection
If you haven’t already done so, unpack the Mediatrix C7 Series device. Carefully remove it from the package
and packing material. The Mediatrix C7 Series package contains the following items:

1 x Mediatrix C7 Series unit

1 x power supply for the country in which you are using the Mediatrix C7 Series

1 x Bumpon
TM
kit for desktop use

1 x Printed Flyer
You may also need additional 10/100 BaseT Ethernet RJ-45 cables.
Location and Mounting Requirements
The Mediatrix C7 Series is suited for use in an office environment where it can be wall-mounted or free
standing.
Location
Install the Mediatrix C7 Series in a well-ventilated location where it will not be exposed to high temperature or
humidity. Do not install the Mediatrix C7 Series in a location exposed to direct sunlight or near stoves or
radiators. Excessive heat could damage the internal components.
When deciding where to position the Mediatrix C7 Series, ensure that:

The Mediatrix C7 Series is accessible for future upgrade, maintenance and troubleshooting,
and cables can be easily connected.

The cabling is away from the following:
• Sources of electrical noise such as radios, transmitters, and broadband amplifiers.
• Power lines and fluorescent lighting fixtures.
• Water or moisture that could enter the casing of the Mediatrix C7 Series.

The airflow is not restricted around the Mediatrix C7 Series or through the vents of the unit. The
unit requires a minimum of 25 mm (1 in.) clearance.

The operating temperature is between 0
o
C and 40
o
C.

The humidity is not over 85% and is non-condensing.
Warning:
The analog lines of the Mediatrix C7 Series are not intended for connection to a
telecommunication network that uses outside cable. This applies to models with standard FXS (not long
loop) connectors.
Warning:
To prevent fire or shock hazard do not expose the unit to rain or moisture.