Media5 Mediatrix 4104, Справочное руководство

Страница: 95 / 466

Digit Maps Reference Manual (SIP Version)
Mediatrix 4104 73
Using the # and * Characters
It may sometimes be required that users dial the “#” or “*” to make calls. This can be easily incorporated in a
digit map:
xxxxxxx#
xxxxxxx*
The “#” or “*” character could indicate users must dial the “#” or “*” character at the end of their number to
indicate it is complete. You can specify to remove the “#” or “*” found at the end of a dialed number. See
“General Parameters” on page 74 .
Using the Timer
You can configure the Timer. See “General Parameters” on page 74 for more details. It indicates that if users
have not dialed a digit for the time defined, it is likely that they have finished dialing and the Mediatrix 4104
can make the call. A digit map for this could be:
[2-9]xxxxxxT
Calls Outside the Country
If your users are making calls outside their country, it may sometimes be hard to determine exactly the number
of digits they must enter. You could devise a digit map that takes this problem into account:
001x.T
In this example, the digit map looks for a number that begins with 001, and then any number of digits after that
(x.).
Example
Table 50 on page 71 outlined various call types one could make. All these possibilities could be covered in
one digit map:
(0T|00T|[1-7]xxx|8xxxxxxx|#xxxxxxx|91xxxxxxxxxx|9011x.T)
Validating a Digit Map
The Mediatrix 4104 validates the digit map as you are entering it and it forbids any invalid value.
Note:
When making the actual call and dialing the number, the Mediatrix 4104 automatically removes the
“T” found at the end of a dialed number, if there is one (after a match). This character is for indication
purposes only.