Mecmesin MultiTest-0.5i, Руководство по эксплуатации

Страница: 19 / 34

A Guide to Safe Use of Mains Powered Test Systems
Mecmesin
 15
5. Servicing, Calibration, Maintenance and Repair
Once the test system is installed it should provide a reliable long-term resource for
specified testing.
Mecmesin test systems contain no user-serviceable parts other than fuses within the
mains inlet socket.
5.1 Replacing fuses
To replace a fuse, first switch off the mains power at the back of the test system and
disconnect the power lead.
Insert the tip of a screwdriver into the fuse carrier slot as shown below, and gently lever
the carrier out:
Removing the fuse carrier Carrier removed to replace fuse Selector set to 220-240 V
The carrier contains two fuses. These should both be replaced with fuses of the same
rating and size as those removed. Refit the fuse carrier with the selector matched to the
mains voltage being used, as shown above.
Reconnect the mains power lead and switch on.
5.2 Servicing and calibration
To ensure optimal safe performance, your test system must be regularly serviced and the
Force or Torque transducers calibrated by Mecmesin Ltd or an authorised distributor.
If the system is damaged in use, advise your local supplier and have the
machine repaired to a safe working condition. Do not use the machine until
it has been repaired.