NEED HELP? 1-800-832-2966
12
Depth Regulator
1) The depth regulator is installed with the point facing upwards for shipping.
2) Remove the depth regulator securing pin and clip.
3) Flip the depth regulator over and re-install with the point down.
4) Secure once more with the pin and clip.
PREPARING THE MACHINE FOR USE
Using this Machine for the First-Time
STOP!
The following section describes the required steps for preparing this machine for the first use. Improper assembly or failure to correctly
perform these steps can damage this machine and/or shorten its life. If you are still unsure about how to perform any of these steps
after reading this section, call 1-800-832-2966 Monday - Friday, 9 AM - 6 PM Central Time for customer service.
Once assembled, if this machine is being used for the first time, the following steps are required to prepare it for operation:
Step 1
–
Mix Fuel and 2-Cycle Oil
This machine requires 2-cycle engine oil to be mixed with the fuel to function. FAILURE TO USE A 50:1 FUEL/OIL MIX WILL RESULT IN
SERIOUS ENGINE DAMAGE! FOR THE PROPER RATIO ADD 2.6 OUNCES OF HIGH QUALITY 2-CYCLE OIL TO EACH GALLON OF
GASOLINE.
Do not mix fuel in the cultivator’s fuel tank, use a separate fuel rated container.
A bottle of 2-cycle oil is included for your
convenience.
Step 2
–
Fueling
Use only unleaded gasoline only with an octane rating of 89 or higher for the fuel/oil mix.
DO NOT USE E85, OR FUEL WITH
MORE THAN 10% ETHANOL CONTENT. DOING SO CAN CAUSE ENGINE DAMAGE.
Add fuel mix to the fuel tank, be sure to
avoid overfilling, leave 1 inch of air space in the top of the tank when fueling to allow for expansion. Maximum Capacity: .85 Liters
Depth Regulator
