NEED HELP? 1-800-832-2966
13
GENERAL ASSEMBLY INSTRUCTIONS
Installing Wheels and Support Feet
1. Before adding oil or fuel, install the
wheels and feet on Model 4350/DF,
8350DFE, 9350E/DFE.
2. Carefully tip the generator
backwards when looking at the
control panel and insert the support
feet under the frame.
3. Resting the generator on the feet,
use the included 6mm nuts and
bolts to attach them to the frame.
4. Prepare one of the wheels by
inserting the axle bolt and sliding a
bushing in place.
5. Carefully lift the rear of the
generator and slide the assembly
into the frame bracket. Secure the
axle bolt with the included lock nut.
6. Install the wheel on the opposite
side following instructions 4 and 5.
7. The handle can now be unfolded as
well by removing the safety
securing pin and lifting the handle
upward.
8. Secure the handle in the open
position by re-inserting the safety
locking pin.
9. Connect the battery cables to the
battery for electric start if equipped;
red ended cable to the positive (+),
and black ended cable to the
negative(-).
