Page 13
84RT Seres Speed Level™ - Operator’s Manual
July 2021
Secton 6 - Functons Test & Operatng Instructons
Operating Instructions
DO NOT operate this machine until you have read and understood the Safety section of this
manual, have performed the Pre-Start Inspection, Routine Maintenance, and Functions Test,
have inspected the jobsite for hazards, and have learned the operating procedures for this
machine�����
This section provides instructions for each function of machine operation. Follow all safety rules and
instructions.
This machine may be operated by trained and authorized personnel only. If multiple operators use
this machine, all must be qualified and authorized to use it. New operators must perform a Pre-Start
Inspection (see page 29) and Functions Test prior to operating the machine.
Operators must comply with employer, job site and governmental rules regarding the use of personal
protective equipment – see “Fall Protection” on page 3.
Prestart
ART_2506 R2
Perform Prestart Inspection (see page 29).
Check base control EMERGENCY STOP switch – turn clockwise to reset.
ART_2507 R2
Check platform control EMERGENCY STOP switch – turn clockwise to reset.
ART_2356
Check Battery Disconnect switch in control module next to lower control box.
Must be in ON position.
Starting Engine from Lower Control Panel
ART_2404 R1
Be sure that the upper and lower EMERGENCY STOP Switches are reset.
Upper Control Box:
Turn Engine Start Switch to RUN.
ART_3236
Lower Control Box:
Turn key switch to BASE.
