Page 8
84RT Seres Speed Level™ - Operator’s Manual
July 2021
Secton 4 - Hazards
Tip-over Hazards
ART_3065
ART_3064
ART_3063
ART_3069
ART_3071
ART_3059
DO NOT exceed the maximum platform capacity (see Specifications). The weight of
options and accessories will reduce the rated platform capacity and must be factored
into the total platform load. Refer to the decals on the options.
DO NOT elevate the platform when the machine is on a surface that is soft, non-
planar, or exceeds the leveling range of the machine.
The tilt alarm will sound when the machine is off level. If the alarm sounds when the
platform is lowered, DO NOT attempt to elevate the platform. Carefully lower, re-level
the machine, or move the machine to a surface within the leveling range.
If the alarm sounds when the platform is raised, use extreme caution to lower the
platform.
Driving in stowed position:
use extreme care and slow speeds when driving across
uneven terrain, debris, unstable or slippery surfaces, and near holes or drop-offs.
Driving with the platform elevated:
DO NOT drive on or near uneven terrain,
unstable surfaces or other hazardous conditions.
DO NOT push off or pull toward any object outside the platform.
Maximum Allowable Side Force
ANSI and CSA
CE and AUS
250 lbs (1100 N)
90 lbs (400 N)
DO NOT elevate the platform when wind speeds are in excess of 28 m.p.h. (12.5
m/s). If these wind speeds occur when the platform is elevated, carefully lower and
discontinue operation.
DO NOT increase the surface area of the platform (i.e. cover the rails with tarp or
plywood). Increased surface area exposed to the wind will decrease machine stability.
DO NOT attach overhanging loads or use the machine as a crane.
DO NOT transport tools and materials unless they are evenly distributed and can be
safely handled by personnel in the platform. Secure all tools and loose materials to
prevent injury to personnel below the platform.
DO NOT alter or disable machine components that may affect safety and stability.
DO NOT replace items critical to machine stability with items of different weight or
specification.
DO NOT modify or alter the work platform without written permission from MEC, as
modifications can increase weight and/or surface area resulting in instability.
DO NOT place ladders or scaffolds in the platform or against any part of the machine.
DO NOT use the machine on a moving or mobile surface or vehicle.
Ensure that all tires are in good condition, air filled tires are properly inflated and lug
nuts are properly torqued.
