Mea SMARTPACK 35, Руководство владельца/оператора

Страница: 14 / 41

Document No 7214-D0001-01
10
Mobile Energy Australia Pty Ltd 39 Dulacca Street, Acacia Ridge QLD 4110 Australia ABN 98 674 578 946
P: +61 7 3273 6803 E: sales@mobileenergyaustralia.com.au www.mobileenergyaustralia.com.au
6. SCHEDULE MAINTENANCE
This section is dedicated to the maintenance schedules as outlined by the engine and compressor
manufacturer under standard operating conditions. If the conditions are severe steps need to be taken for
the affected areas to be maintained at shorter intervals.
Daily inspection should happen before each start-up.
Interval Compressor Petrol Engine Diesel Engine
Action to be taken
Periodically During
Operation
Observe all gauge readings. Note any change from the normal reading and determine the
cause. Have the necessary repairs made?
(Note: “Normal” is the usual gauge reading
when operating at similar conditions on a day-to-day basis.)
Periodically as
required
Inspect and replace spin-
on coalescing element if
necessary.
check fuel filter periodically.
Inspect and clean oil
cooler fins.
Check for oil and/or air
leaks.
AFTER FIRST 50
HOURS OF
OPERATION
Change engine oil and oil filter
Every 10 Hours or
Daily
Check the compressor oil
level.
Check engine oil level
Check air filter/s and connecting hose and clamps
Check for oil and air system, including hoses, for leaks
Every 25 Hours or
Monthly
Drain water from than and
check Compressor oil
level
Inspect engine
After first 50 hours
of operation
Check system for oil
and/or air leaks
Check fuel hose and clamping band.
Check engine/compressor mounts fastener torque. Change engine oil.
Check belt and pulleys for signs of wear - note that
belt normally gives off blue particles until It runs in Replace oil carter. (In case of
low use; every 6 months)
Every 100 Hours
Check engine/compressor mounts fastener torque.
Check compressor oil
level
Change engine oil
Check system for oil
and/or air leaks
Clean air cleaner element
Check engine/compressor/generator mounts for excessive wear and fastener torque.
Every 200 Hours of
Operation or 6
months Change engine air
intake filter if
necessary
Every 400 Hours of
operation or 9
months Engine
compressor see
Service Kit List
Change compressor oil
3L Change Engine oil
1.1L
Change compressor oil
filter Change engine oil
filter
Change compressor air
filter Replace fuel filter
element if necessary
Change Spark Plug
Check valve
clearance
Check belt and pulleys for signs of wear
Check engine/compressor mounts fastener torque.
Every 500 Hours (in
case of low use
every year)
Setting and injectors
cleaning.
Setting rocker arms
clearance.