Mea 7236, Руководство владельца/оператора

Страница: 10 / 81

Document No
7235-D0001-01 6
4. OPERATING PROCEDURE
CAREFULLY READ THE OPERATING INSTRUCTIONS BELOW. FAILURE
TO ADHERE TO THE FOLLOWING COMPRESSOR OPERATING
INSTRUCTION COULD RESULT IN SERIOUS INJURY.
1. Check Oil Level (Refer to Page 15).
2. Check Hoses and fittings for leaks. Make sure the hoses are not loosened nor damaged.
3. Check and make sure hydraulic supply/return/drain are installed correctly (Refer to Page 7).
4. Check Air Filter for Blockage.
5. Check the Safety circuit switch operation (Reset Switch).
6. Switch on the vehicle and activate the vehicle flow control (turn PTO on; for vehicle mounted system).
In other systems, start the hydraulic system by starting the hydraulic pump.
7. Turn on the compressor either at the control box (or in the cab) and ensure it is in the unloaded
state (check load/unload switch).
8. Turn on the unload/load switch to load and see if the compressor builds pressure to the regulated
setting.
9. Plug an air tool into the air outlet and operate. Ensure that the compressor works as required.
10. When the work is finished, switch the compressor to unload.
11. Switch off at either the control box or in Cab and switch off the vehicle.
12. It is good practice to check for any visible signs of hydraulic fluid leakage and or compressor fluid
leakage after each use.
WARNING