Technical Manual
Glass Room Temperature Controller Smart SCN-RTRGx.02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
•
Germany
Phone: +49-2263-
880 • [email protected] • www.mdt.de
22
22
In the upper half of the display, there are different ways to show the controller function.
A text describing the controller, for example, can be entered in the "
Labelling (control function)
"
field.
Status display
Here you determine whether only the current setpoint (in large letters) or the setpoint and actual
value (in small letters) are to be displayed.
Symbol
With this selection, either the "Heating/Cooling" operation or a "HVAC" operation mode can be
displayed. All symbols can also be individually set in colour.
Display control value
When activated, the current setting value can be displayed here via a bar symbol. This is a purely
visual display, not a numerical value. On the other hand, the control value can be shown via the
colour of the "Heating" or "Cooling" symbol.
Symbol für Eco/Night mode
According to the KNX specification, this is the same operating mode. It is defined here which
symbol is displayed for this operating mode. According to the selection, the displayed text for
"Symbol colour for Eco" or "Symbol colour for Night" changes in the parameters below.
4.2.4 User-defined colours
Up to 3 user-defined colours can be mixed:
Figure 7: Display settings
–
User-defined colours
The user-defined colours can be mixed with the corresponding red / green / blue share and then be
used for the display of the symbols.
