Technical Manual
Glass Room Temperature Controller Smart SCN-RTRGx.02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
•
Germany
Phone: +49-2263-
880 • [email protected] • www.mdt.de
21
21
4.2.3 Representation of the controller
The following settings for the representation of the controller are available:
Figure 6: Display settings
–
Representation of the controller
The following table shows the possible settings:
ETS-Text
Dynamic range
[Default value]
Comment
Labelling
Free input
[up to 15 bytes allowed]
Enter a text to describe the
controller.
Status display
▪
setpoint temperature (big)
▪
actual and setpoint
temperature (small)g
Defines how the status of the
controller is to be shown in the
display.
Symbol
▪
Heating/Cooling
▪
HVAC-Mode
▪
not active
Determines how the setpoint
temperature is to be displayed.
Symbol:
Heating/Cooling
Display control value
▪
not active
▪
via bar
▪
via symbol colour
Setting for how the control value
is to be shown in the display.
Symbol colour for
Heating/Cooling
any colour
[according to selection]
Setting the colour with which the
symbols are displayed.
Symbol colour for control
value
= 0% (Heating)/(Cooling)
> 0% (Heating)/(Cooling)
any colour
[according to selection]
Setting of the colour with which
the symbols are displayed.
Only for "Display control value"
via "Colour of symbol".
Symbol:
HVAC-Mode
Display control value
▪
not active
▪
via bar
Setting for how the control value
is to be shown in the display.
Symbol for Eco/Night mode
▪
Eco symbol
▪
Night symbol
Setting the symbol for the
operating mode.
Symbol colour for
Comfort/Standby/Eco/Night/
Frost/Heat protection
any colour
[according to selection]
Setting the colour with which the
symbols are displayed.
Symbol:
not active
Display control value
▪
not active
▪
via bar
Setting for how the control value
is to be shown in the display.
Table 13: Display settings
–
Representation of the controller
