MDS 05-3624A01, Rev. B
OEM Series™ I/O Guide
21
•
PWR
is set to
H
[+33 dBm (2 watts)]
•
RXTOT
is set to
NONE
•
TOT
is set to
OFF
All other commands stay at their previously established settings.
KEY
This command activates the transmitter. The transmitter stays keyed
until either the DKEY command is entered, or the transmitter time-out
timer is enabled and times out. See also the
DKEY
and
TOT
commands.
NOTE:
The
KEY
and
DKEY
commands are not intended for normal
operation. They are tools for field testing and installation.
OWM [XXX...]
This is a command to display or set an owner’s message. To program
the owner’s message, type
OWM
then the message, followed by
.
The maximum number of characters that can be entered is 30.
To display the owner’s message, type
OWM
then
. The owner’s
message appears on the display.
OWN [XXX...]
This is a command to display or set an owner’s name. To program the
owner’s name, type
OWN
then the name, followed by
. The
maximum number of characters that can be entered is 30.
To display the owner’s name, type
OWN
then
. The owner’s
name appears on the display.
PWR [L | M | H]
NOTE:
This function may not be available, depending on certification
requirements for a particular region.
This command displays or sets the desired RF forward output power
setting of the radio. The
PWR
command parameter is specified as
L
(low),
M
(medium), or
H
(high). The default setting is
H
. The values of
L
,
M
, and
H
are:
L
= 20 dBm (100 mW)
M
= 30 dBm (1 W)
H
= 33 dBm (2 W)
ENTER
ENTER
ENTER
ENTER
