MDC Robson XTT 2015, Руководство пользователя, Страница: 32 / 108

www.marketdirect.com.au
I
Ph: 1300 494 494
I
©Copyright
I P a g e | 28
Site Power
The Projecta charger in your camper is connected via the 15A exterior socket. To use site power, you will require
a 15A power lead connected to a 15A outlet (figure 1). In the event a 15A outlet is unavailable you will need a
conversion box that will step up from 10A to 15A with a safety switch. Never leave power leads coiled when in
use, lay the lead out back and forward in a manner that won’t be a trip hazard or risk damage to the lead.
Operating the Jockey Wheel
The rated load capacity of a jockey wheel is achieved when the jockey wheel is retracted to its lowest position.
When moving the trailer on the jockey wheel, always lower it as far as possible but still allowing the wheel to
swivel as you steer the trailer.
Stabiliser Legs
Stabiliser legs are installed to stabilise the camper or camper when setup. Stabiliser legs should never be used to
jack a trailer as they are comprised of small bevel gears held in place by small roll pins that will break if
overloaded. Stabilisers are best set vertical or 90 degrees to the chassis where possible. When set and an angle
the user must be careful not to overload them causing locking pins or the leg itself to bend. Never use impact
wrenches to wind the legs, the impact may damage the gears. When using a power tool, use an electric drill with
a safety clutch set low to medium to avoid injury or damage to the stabilisers.