MD Helicopters 369-500, Инструкция по техническому обслуживанию

Страница: 268 / 722

CSP-HMI-3
MD Helicopters, Inc
.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI − 3 Book TOC ]
[ Chapter 96 TOC ]
Page 602
Revision 13
96-00-00
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright
©
1999 − 2016 by MD Helicopters, Inc.
G96-0033-1
NOTES:
1. A CRACK, TEAR, OR CUT ACROSS OUTER WEB WHICH DOES
NOT EXTEND MORE THAN 50% OF AREA BETWEEN ID AND OD.
2. MINOR GOUGES, CUTS, AND TEARS IN CAVITY SEPARATOR.
3. SLIGHT IMPERFECTIONS, MINOR SCUFFS, SCRATCHES, SMALL
CHIPS, NICKS OR GOUGES WHICH DO NOT PENETRATE THROUGH
OUTER WEB OR EXTEND INTO CAVITY SEPARATOR.
4. MOLD FLASH OR OTHER MOLD IMPERFECTIONS WHICH DO NOT
CAUSE VOIDS BETWEEN GROMMET AND WIRE AFTER CONTACT
IS INSTALLED.
NOTE 1
NOTE 2
NOTE 3
NOTE 4
ACCEPTABLE DEFECTS
(WIRE ENTRY INSERT)
Figure 602. Accept/Reject Criteria for Connector Defects (Sheet 1 of 6)
G96-0033-2
NOTE 1
NOTES:
1. A GOUGE, CUT, TEAR, CRACK, OR CHIP EXTENDING FROM THE
OUTER EDGE OF THE GROMMET FACE TO A CONTACT CAVITY.
2. A GOUGE, CUT, TEAR, CRACK, OR CHIP ACROSS OUTER WEB
EXTENDING INTO CAVITY SEPARATOR OR TO ANOTHER CONTACT
CAVITY.
3. MORE THAN ONE CRACK, TEAR, OR CUT ACROSS OUTER WEB
WHICH DOES NOT EXTEND MORE THAN 50% OF AREA BETWEEN ID
AND OD.
4. A CHIP, NICK, OR GOUGE WHICH PENETRATES OUTER WEB.
5. SEVERE GOUGE, CUT, TEAR, CRACK, OR CHIP IN THE CAVITY
SEPARATOR.
NOTE 2
NOTE 3
NOTE 4
NOTE 5
UNACCEPTABLE DEFECTS
WIRE ENTRY INSERT)
Figure 602. Accept/Reject Criteria for Connector Defects (Sheet 2 of 6)