MD Helicopters 369-500, Инструкция по техническому обслуживанию

Страница: 191 / 722

CSP-HMI-3
MD Helicopters, Inc
.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI − 3 Book TOC ]
[ Chapter 95 TOC ]
95-30-00
Page 107
Revision 13
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright
©
1999 − 2016 by MD Helicopters, Inc.
Table 112. Input/Output Signals − Voice Warning LRU (600N4514 − 3/ − 5)
Pin Description Function Voice message
A Input fron N1 sensor Detects frequency below 9817 HZ (ECU
manual mode)
Engine out
B Power input 23 − 30 Vdc (Bus) N/A
C Output Audio out, 100 Mw into 600 Ohms N/A
D Input Contact to ground Fuel flow fixed
E Input Power ground N/A
F Input Contact to bus from FADEC Engine out
G Audio in ( − 5 only) Audio from COMM N/A
H Input Case ground N/A
K Input Detects voltage above 2.98 Vdc Power
L Input from rotor sensor Detect frequency below 1321 HZ Low rotor
P Input Contact to bus Voise warning test
S Input Contact to bus Fire
T Input Contact to ground E.C.U. manual
U Output Bus voltage out to ignition exciter if in ECU
manual and low N1 or low rotor
N/A
NOTE:
Pins J, M, N & R are not used − 3 or − 5.
Pin G not used on − 3.
Table 113. Input/Output Signals − Voice Warning LRU (600N4515 − 1)
Pin Description Function Voice message
A Input fron N1 sensor Detects frequency below 9817 HZ (ECU
manual mode)
Engine out
B Power input 23 − 30 Vdc (Bus) N/A
C Output Audio out, 400 Mw into 75 Ohms N/A
D Input Contact to ground Fuel flow fixed
E Input Power ground N/A
F Input Contact to bus from FADEC Engine out
G Audio in ICS audio N/A
H Input Case ground N/A
J Output Audio 2, 400 Mw into 75 Ohms N/A
K Input Detects voltage above 2.98 Vdc Power
L Input from rotor sensor Detect frequency below 1321 HZ Low rotor
P Input Contact to bus Voise warning test
S Input Contact to bus Fire
T Input Contact to ground E.C.U. manual
U Output Bus voltage out to ignition exciter if in ECU
manual and low N1 or low rotor
N/A
NOTE:
Pins M, N & R are not used.