MD Helicopters 369-500, Инструкция по техническому обслуживанию

Страница: 155 / 722

CSP-HMI-3
MD Helicopters, Inc
.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI − 3 Book TOC ]
[ Chapter 95 TOC ]
95-10-30
Page 205
Revision 7
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright
©
1999 − 2016 by MD Helicopters, Inc.
(6). To replace, insert indicator into opening
in instrument panel and secure at lower
right corner with screw and nut.
(7). Remove caps from indicator and
reducer.
(8). Connect reducer to indicator.
I. Reducer, Connectors, Tees and Tubes
Replacement
(1). Disconnect reducers, connectors, tees
and tubes that join the IVSI to the
altimeter and airspeed indicator.
(2). Cap all openings.
(3). To replace, remove caps from reducers,
connectors, tees, tubes, altimeter and
airspeed indicator and reconnect as
shown.
J. Lamp Assembly Replacement
(1). Verify that BATT-OFF-EXT switch is
in OFF position.
(2). Disconnect lamp assembly wire
L528K20 from terminal block TB700-2,
pin D.
(3). Remove wire L528K20 from straps
between TB700-2 and lamp assembly.
(4). Remove lamp assembly mask from
lamp assembly mounting plate.
(5). Remove lamp assembly mounting plate
from instrument panel.
NOTE:
If new lamp assembly is to be installed,
the furnished wire L528K20 must be identi­
fied, routed, cut to fit, and terminated with
new pin.
(6). To replace, install lamp assembly
mounting plate to instrument panel
and IVSI with screws and nuts.
(7). Route wire L528K20 through opening
in instrument panel.
(8). Install lamp assembly mask to mount­
ing plate.
(9). Continue routing wire L528K20
through straps to TB700-2 and connect
to terminal D.
4. Instantaneous Vertical Speed Indicator
Inspection
NOTE:
(Ref. Sec. 95-10-00 for Pitot-static sys­
tem inspection procedures)
(1). Inspect reducer, connectors, tees, and
tubes for nicks, cuts and abrasions.
Replace any damaged component.
(2). Check lamps. Replace bulb if burned
out.
(3). L/H command T-Panels:
Inspect bolt light assembly for damage.
Check wire for nicks, cuts or broken
strands. Check pin for proper insertion
in terminal block.
(4). R/H command T-Panels:
Inspect lamp assembly for damage.
Check wire for nicks, cuts or broken
strands. Check pin for proper insertion
in terminal block.
A. Instantaneous Vertical Speed Indicator
Repairs
(Ref. Instrument Repair, Sec. 95-00-00)
Table 201. Troubleshooting Instantaneous Vertical Speed Indicator
Symptom Probable Cause Corrective Action
Excessive lag in vertical speed
indication
Indicator defective Replace indicator.
Erroneous vertical speed indication
(airspeed or altimeter erratic as
well)
Disconnected or loose static
pressure line
Reconnect or repair static pressure
line.
Erroneous vertical speed indication
(airspeed or altimeter correct)
Indicator defective Replace indicator.