1
BATTERY HOLDER
ANTENNA
GREEN
RED
LIGHT
LIGHT
PYRO
SENSOR
PULSE COUNT JUMPER TAMPER SWITCH
WPIR Motion Sensor
WPIR3
Introduction
The
WPIR3 Motion Sensor
is
an infrared movement sensor, which is
battery operated and communicates with a receiver via radio
transmission (RF). This detector is easy to install, provides excellent
detection sensitivity and has a long battery life. The WPIR3
Motion
Sensor
can transmit different codes to your Receiver:
1.
Alarm
2.
Tamper
3.
Low Battery
•
NEVER TOUCH THE PYRO SENSOR
•
DURING THE WARM UP PERIOD, (first 5 minutes after installing the batteries) THE DETECTOR WILL NOT
RESPOND TO THE TAMPER SWITCH OR TO MOVEMENT IN FRONT OF THE DETECTOR. YOU MUST
WAIT 5 MINUTES BEFORE IT WILL RESPOND.
Setup
Remove the front cover of the detector by unclipping the case from the top. Once the case is open, you will see
a small square piece of insulation under one of the battery terminals. Remove this insulation. The Red & Green
LED's will flash together 6 times to confirm that the detector now has power connected. Now replace the front
cover.
Warm Up Period:
You must wait approximately 5 minutes for the
detector to warm up after connecting the
batteries. During this period the detector will
not detect or transmit. Once the detector has
warmed up, the green and red lights will flash
together 6 times to confirm that the warm up
period has finished. The detector will now
automatically enter Normal (Intelligent Power
Saving) Mode - refer to page 2.
Battery Type: 2 x Lithium button cells
Model: CR2450
Voltage: 3 Volts
+
+
IMPORTANT NOTES:
Made in Australia
A.C.N 001 621 610
