McLaren ARTURA, Руководство пользователя

Страница: 199 / 326

Programming a rolling code device
NOTE: A second person may make the
following steps quicker and easier.
The next steps are time sensitive and
may need to be tried multiple times.
1. Locate the Learn , Smart or Program button
on the motor-head unit, located on the
garage door opener's receiver. Refer to the
garage door opener manual to identify the
button.
2. Press and release the Learn , Smart or
Program button. There are typically 20
seconds to initiate the next step.
3. Within 20 seconds, return to the vehicle
and press and release the programmed
HomeLink® button up to three separate
times to activate the device. If the device
activates, programming is complete.
Programming additional HomeLink buttons
Repeat steps 2 to 5 , from Programming a single
HomeLink button, page 4.52.
Reprogramming a single HomeLink button
When the following procedure is performed,
buttons which already have devices programmed
to them can be overwritten.
1. Press and hold the HomeLink® button that
you would like to reprogram,
(1) , (2) or (3) .
The HomeLink® indicator light (4) will begin
flashing slowly.
2. While continuing to hold the HomeLink®
button, position the garage door opener
remote control 2–8 cm (1-3 in) away from
the interior mirror and press and hold the
button on the garage door opener remote
control, until the HomeLink® indicator light
(4) changes from flashing slowly, to either
solid or flashing rapidly.
NOTE: The change in flashing indicates
the frequency signal has been learned.
NOTE: Some remote device systems
require the operator to press and
release the garage door opener remote
control button every 2-10 seconds
during programming.
3. Press the programmed HomeLink® button
and observe the HomeLink® indicator light
(4) .
If the indicator light (4) is solid,
programming is complete and your device
should activate when the HomeLink®
button is pressed and released.
4.53
Central Display
Connected Car
R