15
11. Using the Knurled Ring surfaces on the projector lens
adjust the size and focus of the image. Refer to figure 7.
12. Rotate the projector clockwise or counterclockwise
about the center horizontal axis to minimize any
horizontal keystone distortion. The top and bottom
horizontal lines of the Crosshatch Test Pattern should
be parallel with the top and bottom edges of the screen.
Refer to figures 5, 12 and 13.
13. Using the knurled
ring surfaces on
the projector lens
to adjust the size
and focus of the
image. Refer to
figure 7.
14. Repeat steps 6 thru
13 until no further
improvements can
be made.
Note: Correction
for any
vertical
keystone
distortion
of the im-
age will be
performed
later during
the elec-
tronic setup
adjustments
on page 23.
15. Press the STAND-
BY/ON Push-
button on the
Projector Control
Panel or the PROJ
ON Push-button
using the Remote
Control.
16. Temporarily place the previously removed protective
cover onto the projector lens.
17. Remove the AC Power Cord from the projector.
18. Proceed to the “How to connect the MDLP1”
on page 17.
centered vertically on the screen the Crosshatch
Test Pattern lines are again white in color.
9. Using the Knurled Ring surfaces on the projector lens
adjust the size and focus of the image. Refer to figure
7.
10. Rotate one or both of the projector feet to line up the
top and bottom horizontal lines of the Crosshatch Test
Pattern to be parallel with the top and bottom edges of
the screen. Refer to figures 5 and 10.
Note: If more than several turns are needed there is a
release lever located next to the foot for rapid and
large changes in height. Refer to figure 11.
Initial Setup
Screen
Figure 8
Screen
Figure 9
Figure 10
Figure 11
������
Figure 13
Figure 12
������
