McHale
Pro Glide B9000
Butterfly Disc Mower
42
After all hydraulic pressure is released, disconnect all hydraulic lines from the tractor.
Then disconnect the 7 pin lighting plug. Finally disconnect the PTO shaft followed by
the top-link and lift arms and drive away from the mower.
8.2 Conditioner adjustment (LH & RH)
To change the conditioner speed, lift the curtain and side cover beside the gearbox to
expose the nearest drum, which must be rotated a little to allow the gears to re-mesh
as the lever is moved from one speed to the other.
8.3 Swath width adjustment (LH & RH)
The swath width can be adjusted between 1.3 and 2.3 m wide. The adjustment is
achieved by loosening the eye bolts holding the swath plates on each side and
CAUTION: Ensure the tractor is shut down
Ensure that the tractor engine has been shut down, the key removed
and the brakes applied before carrying out the following procedure.
Conditioner plate: Varying the distance between
the rotor flails and the conditioning plate affects
the amount of crop conditioning as it passes
through the gap. There are six specific lever
positions or settings available. The - and +
symbol indicates less or more aggressive,
depending on the degree of conditioning desired
for the crop being cut.
Conditioner speed: Varying the conditioner
speed also affects the amount of crop
conditioning as it passes through. There are two
specific lever positions or settings available. The
700 and 1,000 symbol indicates less or more
aggressive, depending on the degree of
conditioning desired for the crop being cut.
NOTE: For consistent results ensure settings are correct
All settings and adjustments must be repeated or mirrored for left, right
and front mowers to give consistent results.
CAUTION: Ensure the tractor is shut down
Ensure that the tractor engine has been shut down, the key removed
and the brakes applied before carrying out the following procedure.