McCulloch B26PS, Руководство оператора, Страница: 15 / 474

• Let the end of the trimmer line strike the ground
around objects
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass. (Fig. 61)
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
4. Use 80 % throttle when you cut grass near objects.
(Fig. 62)
To cut the grass
1. Make sure that the grass trimmer line is parallel to
the ground when you cut. (Fig. 63)
2. Do not push the trimmer head to the ground. The
ground and the product can be damaged.
3. Do not let the trimmer head touch the ground
continuously, it can cause damage to the trimmer
head.
4. Use full throttle when you move the product from
side to side to cut grass. Make sure that the grass
trimmer line is parallel to the ground. (Fig. 64)
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING: Clean the trimmer head cover
each time you assemble new trimmer line to
prevent unbalance and vibrations in the
handles. Also do a check of the other parts
of the trimmer head and clean it if
necessary.
To replace trimmer line
Refer to the last page of this operator's manual.
Maintenance
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Maintenance schedule
Maintenance Daily Weekly Monthly
Clean the external surface. X
Clean the air filter. Replace if it is necessary. X
Examine the function of the throttle trigger lock and the throttle. X
Examine the stop switch. X
Examine the guards. X
Examine the trimmer head. X
Examine the locknut. X
Examine for fuel leaks. X
Make sure that the grass blade is aligned with the center, that it is sharp and
does not have damages on the blade or the center hole.
X
Make sure that the cutting attachment does not rotate at idle speed. X
Apply grease to the two-piece shaft. X
Examine the starter rope handle and the starter rope. X
1228 - 002 - 08.09.2020 15